With the increasing use rate of resin tiles, we often encounter some problems during the early installation and later use. Today, Laizhou Jieli Industry & Trade Co., Ltd. experienced experienced technicians on the common series of resin tiles. The questions are answered one by one, such as:
Question 1: When installing the resin tile roof, I accidentally drilled the hole and what can I fill?
A: The wrong drill hole can be filled with glass glue. After filling it, you can use it with confidence and no water leakage.
Question 2: Some resin tile roofs will make a sound when the wind blows. What is the reason? How to solve it?
A: If the resin tile is installed, there is no waterproof layer, and the distance between the purlins is relatively large, or when the tile of the resin tile is fixed, the self-tapping screws are tightened tightly, and there may be a sound when the wind blows. Therefore, when installing, the spacing of the purlins should be laid strictly in accordance with the standard of resin tiles. It should be appropriate when tightening the resin tiles. It should not be too tight. If it is too tight, it will easily cause noise from the wind, but it should not be too loose or too loose. If the tile is not fixed, it is easy to cause water leakage;
Question 3: Is the resin tile raining loud?
A: Because the resin tile itself has the function of noise reduction and noise reduction, the sound insulation effect is better in the comparison of similar roof tiles. Even if the waterproof layer is not laid, the sound of rain can be basically isolated; if it is also covered with waterproof layer, then There will be no more sounds.
Question 4: How to solve the problem of indoor dripping in resin tile roof in winter?
A: The resin tile roof dripping is because the indoor temperature is high in winter and the outdoor temperature is low. When the hot and cold airflow meets on the synthetic synthetic resin tile roof, water droplets will be produced. This is a common physical "condensation" phenomenon. The synthetic resin tile does not absorb water, so if the water droplets condense more, it will drip down. Solution: It is to make the insulation layer on the roof, or to enhance the ventilation and ventilation in the room, there will be no dripping phenomenon.